You are here: Troubleshooting > Error Codes > Errors 20-29 > Error 27

Error 27: Timber Too Thick to Bevel

Variable M585

The saw has attempted to cut a bevel cut but the thickness of the timber (stored in variable P751) is greater than the maximum allowed thickness for bevel cutting (set in variable P539).

What to do now

Press the START button to continue cutting and skip current cut, otherwise stop the saw by holding down the STOP button.

What to do next

  1. Check that the timber loaded into the saw is the correct thickness.
  2. Make sure the timber is not stacked.
  3. Make sure that the 2* Thick checkbox on the Control Bar is NOT checked. Even if not, check and uncheck and try again.